1933 Willys Gasser Drag Car Beautiful 33
Scottrods Body and Chassis Very nice car
1933 Willys Coupe Drag Car
Scottrods Body and Chassis
18 Degree 380 Cubic Inch Smallblock Chevy
Bowtie block
Callies 3.550 Crank
Carillo Rods
JE Pistons 4.135 Bore
Del West Titanium Valves
Crower Stainless Shaft Rockers
707 lift Comp Cams Roller Cam
ATI Balancer
2 Piece intake
MSD Locked Distributor
14.85 to 1 Compression
950 CFM Stealth Billet Carb
Schoenfeld Headers
Magnafuel Quickstar 275 Fuel pump
Jaz Fuel Cell
Optima Battery
PTC Powerglide w/transbrake and PTC Convertor (Both fresh with 1 pass)
MSD 7AL-3
MSD Digital 2-Step
MSD RPM activated switch 2 each
Pro-Cube 2-Plus w/1 timer
Pro-Dial LED Dial-In Boards
Pro-Comp Gauges
Autometer Tach w/recall
Hurst Shifter with Shiftnoid
Safecraft Fire Suppression system
Hoosier 29.5x11.5 Slicks
Sander 15x12 rear wheels
Ron Pope 4 inch drop axle
AFCO Double adjustable shocks
4 Wheel Disk brakes
The wheelie bars for the car are not shown in the pics as I have them off right now for storage.
This car was built for a large driver. I am 6'2” and 275 and there is plenty of room.
I also have the Straight Axle with no drop that was in the car before the previous owner installed the dropped axle that I will give with the car if it is desired, it will get the front end up a few inches if desired. I also have another set of ceramic coated headers that will go with the car.
The Willys was mainly used for 6.0 index racing but runs 5.70-5.80s on a not real aggressive tune.